This item has been shown 17 times.
Winbond PTI-255W V1.2 KDDPTI255W Controller Card FDC IDE Com Printer w/ Cable
From the Manufacturer:
Compatible with IBM' PC/AT disk dr
.Support up to two
Support up to four
interfacing with VESA Local Bus operating
at 50MHz OWS
Support two standard RS
-232 serial ports, one parallel por
and one game
.Jumper select to swap floppy disk
.First serial port selectable as either COM
, COM3 or COM4.Second serial port selectable as either COM2, COM3 or COM4
.Printer port selectable as
either LPTl, LPT2, or LPT3.
Printer port interrupt selectable as IRQ5 or ~RQ7.
HDD controller, FDD cont
, game port, parallel port and
can be individually disabled.
Design with Winbond W83
, Windows 3.1, OSI2 2.X, Novel
.XX/3.1X/4.0X Drivers available.
IBM is the trademark of International Business Machines Corp
This device complies with Part 15 of the FCC Rules
. Operation is subject to the
following two conditions:
s device may not cause harmful interference, and (2)
this device must accept any interference received, including interference
cause undesired operation. Shielded interference cable(s) must be used according to FC15 27
The illustration below will familiarize the user with the layout of the PTI-255W
VL-Bus super 110 card and its onboard ports.
Fig 1 YfI-255W Jumpers & Connectors Location
JUMPERS AND CONNECTORSThe following describes the jumpers and connectors of the super 110 card.Jl --This is a 40-pin IDE HDD connector (IDEO connector).
J2 -- This is a 40-pin IDE HDD connector (Optional IDEI connector).
J3 -- This is a 34-pin FDD connector.
J4 -- This is a 16-pin Game connector.
J5 -- This is a 9-pin Serial connector (COMI/COM3/COM4).
J6 -- This is a 9-pin Serial connector (COM2/COM3/COM4).
J7 -- This is a 25-pin Parallel connector (LPTl/LPT2/LPT3).
LEDI -- This is a 2-pin HDD LED Connector